4 Lpm 14 Watt AquaPro UV Water Treatment System



Can easily be installed after any existing water filter system.

Aqua-Pro UV1 4Lpm 14 watt 240v Ultra Violet Light Disinfection Purifier with 14w ballast controller.

No micro organisms are known to be immune to Ultra Violet light , it’s effective against bacteria, mould, fungal spores, viruses & yeasts. This UV disinfection system represents an economical yet effective solution to water disinfecting without the use of chemicals and has a high flow rate. There is a very real risk of contamination in drinking water from bores, tanks & rivers throughout Australia with even some town supplies carry bacteria & Cysts, Giardia & Cryptosporidium.

This system has a treatment flow rate of 4 Lpm which makes it suitable for single outlet applications where the flow rate is under 4 litres per minute.

It is recommended to have a 5 micron sediment filter before any UV system so the lamp’s protective sleeve does not get covered with sediment build up also by reducing the sediment all bacteria comes in contact with the Ultra Violet light. Water enters from one end and is spiralled around the Stainless Steel vessel for maximum contact time before leaving the outlet port. Depending on your water supply this unit may only need one easy service a year where you remove the lamp protective quartz sleeve and wipe clean for best light output.

Lamps are recommended to be replaced every 12 months to keep the system working at peak bacteria killing performance. The lamp is connected to a ballast which has indicator lights showing that the system is working correctly. 14w AquaPro Ballast.

Lamps are easily replaced by sliding the new lamp inside the quartz thimble.

The UV vessel is made from 304 Stainless Steel rated at 120psi

These systems are usually mounted vertically but can be mounted horizontally as well using the C shape mounting clips supplied.

The UV vessel has 1/4″ bsp male inlet & outlet ports. 2 x 1/4″ female thread to 1/4″ tube elbows included.

Dimensions 280mm x 80mm

Maximum killing capacity flow rate of 3.8 Lpm in poor quality water and maximum flow rate up to 6 Lpm in better quality water.

240v ballast cord and plug 14watt 4 pin lamp.

1 Year warranty on S/S chamber and 1 year on ballast, subject to usage. Not suitable for saltwater applications.

It is recommended to use a plug in surge protector before the ballast to reduce the risk of power spikes to the system.

Replacement lamp Part No: 11018 UV Lamp

Replacement ballast 14 watt Aqua-Pro 4 pin

Replacement Quartz Sleeve Part No. 21011

Replacement sleeve o-ring seal Part No: 830 (Requires 2 O-rings)

You may also like…